Railblaza Railblaza Navipack Portable LED Navigation Light Kit The NaviPack Portable LED Navigation Light Kit is the perfect companion for small, tiller steered power boats, inflatables, or as an emergency nav light pack for larger vessels. In one convenient, value-for-money pack you get everything you need to comply with the legal requirements in almost every country and territory. £192.95 inc VAT Add to basket
Avtex Avtex Tourer Three GPS Navigator – Caravan & Motorhome Club Edition The new Avtex Tourer Three comes packed with features specifically for use with caravans and motorhomes. Simply enter the size and weight of the motorhome or towing outfit and the Avtex Tourer Three will give directions to the destination avoiding height, width, and weight restricted roads whilst providing route warnings such as sharp bends or steep hills along the way. £443.99 inc VAT Add to basket
Raymarine Raymarine Blanking Plug SeaTalk ng Blanking Plug - Inserted into unused spur connector positions in 5-way connector and T Piece. Place blanking plug in unused SeaTalkNG Spur sockets to protect them. SeaTalk ng is a robust cabling and connection system compatible with NMEA 2000, built specifically for the marine environment comprising a powered single backbone with two terminators, one at each end. Small diameter cable connectors are used throughout the system to make installation easier. There’s a wide range of cable lengths, all with over-moulded plugs, so there is no need to cut or splice cables. Spur cables connect individual SeaTalk ng products to the SeaTalk ng backbone. Cables and connectors are colour-coded for easy system identification and have quick connect (push-fit, twist-lock) waterproof (IPx6) plugs and sockets. Whether you are looking to expand your current SeaTalk ng system, update your electronics suite or completely refit, it couldn’t be easier with SeaTalk ng. £21.17 inc VAT Add to basket
Oxford Sigma ROX 4.0 GPS Cycle Computer Sensor Set – White The ROX 4.0 bike computer can be positioned on the handlebars in a few easy steps. There is no need to mount cables or sensors.After it is switched on, the ROX 4.0 uses GPS and GLONASS to determine the biker's position in seconds. Along with the user-friendly operation with three buttons, this allows a bike tour to be started right away. Bundle Contains: Bike computer, USB-C cable, Quick-start guide, R1 DUO Heatrate transmitter and chest strap, Overclamp Butler GPS Mount, DUO Magnetless Speed Sensor, DUO Magnetless Cadence Sensor. £232.99 inc VAT Add to basket
Maretron Maretron Micro Double-Ended Cordset Male to Female 1m Grey Double-ended cordsets are used for trunk or drop lines and make for a secure connection and simple timesaving installation. The connectors are keyed for error-free connection and they are waterproof for continued operation even while submerged in the bilge. £60.00 inc VAT Add to basket
Railblaza Railblaza Rod Holder R The Rod Holder R is a light duty rod holder suitable for fresh water and inshore fishing, not trolling for large fish. It will fit into any RAILBLAZA mounting port. The stretchable strap at the front of the holder will wrap around the top for baitcaster and fly reels and round the bottom for spinning reels, keeping your rod and reel safe. £35.89 inc VAT Add to basket
Maretron Maretron Micro Double-Ended Cordset Male to Female 8m Grey Double-ended cordsets are used for trunk or drop lines and make for a secure connection and simple timesaving installation. £93.00 inc VAT Add to basket
Garmin Garmin 6 Pin Transducer to 8 Pin Sounder Connector Block Garmin 8Pin Female to Wire Block Adapter. £81.00 inc VAT Add to basket
Garmin Garmin 8 Pin Transducer to 6 Pin Sounder Cable Garmin 6Pin Female to 8Pin Male Adapter. £38.00 inc VAT Add to basket
Maretron Maretron Micro Double-Ended Cordset Male to Female 6m Grey Double-ended cordsets are used for trunk or drop lines and make for a secure connection and simple timesaving installation. £87.50 inc VAT Add to basket
Raymarine Raymarine Backbone Cable 1m SeaTalk ng Backbone cable - 1 m. In a SeaTalk ng installation, a backbone cable runs through the length of the boat. Individual devices connect to the backbone by spur cables that run to T-pieces on the backbone. The backbone carries both data and power to attached devices. The backbone should be sized so that it will run past every location where an NG or NMEA 2000 device might be installed. Two backbone cable lengths can be joined together by part A06030, a backbone extender. SeaTalk ng is a robust cabling and connection system compatible with NMEA 2000, built specifically for the marine environment comprising a powered single backbone with two terminators, one at each end. Small diameter cable connectors are used throughout the system to make installation easier. There’s a wide range of cable lengths, all with over-moulded plugs, so there is no need to cut or splice cables. Spur cables connect individual SeaTalk ng products to the SeaTalk ng backbone. Cables and connectors are colour-coded for easy system identification and have quick connect (push-fit, twist-lock) waterproof (IPx6) plugs and sockets. Whether you are looking to expand your current SeaTalk ng system, update your electronics suite or completely refit, it couldn’t be easier with SeaTalk ng. £52.18 inc VAT Add to basket
Oxford Sigma ROX 4.0 GPS Cycle Computer – White The ROX 4.0 bike computer can be positioned on the handlebars in a few easy steps. There is no need to mount cables or sensors.After it is switched on, the ROX 4.0 uses GPS and GLONASS to determine the biker's position in seconds. Along with the user-friendly operation with three buttons, this allows a bike tour to be started right away. Contains: Bike computer, GPS mount, Attachment material, USB-C cable, Quick-start instructions. £119.80 inc VAT Add to basket
Railblaza Railblaza Dinghy Visibility Kit The Dinghy Visibilty Kit is the perfect companion for small, tiller steered power boats and inflatables under 7 meters that do not exceed 7 knots. £107.83 inc VAT View product
Railblaza Railblaza Kayak and Canoe Sounder and Transducer Mount The Sounder & Transducer Mount Kit has been developed for kayak anglers needing an easy way to install and remove fish finders or sounders. With this kit you can install and uninstall your fishfinder or sounder in a matter of seconds, no messy adhesives or excessive drilling of fittings required. With our extensive selection of mounts this kit can be adapted to fit any kayak or canoe. £71.42 inc VAT View product
