NASA NASA Exhaust Temperature Monitor The EX-1 continually displays the exhaust gas temperature in wet exhaust systems giving advanced warning of potential problems. An alarm warns of excessive temperatures which could cause exhaust system damage, fires or leaks of toxic gases. It is supplied with a precision temperature sensor and cable to enable simple DIY installation. The EX-1 measures the exhaust gas temperature directly and displays it in degrees centigrade or Fahrenheit. Once the normal working temperature has been established a maximum temperature, a few degrees higher, can be programmed into the EX-1 which will then sound an alarm if that temperature is exceeded. Even a small rise in temperature can indicate a potential problem such as a minor blockage, leak or failing pump which can be corrected before a complete failure occurs. In The Box Monitor; Sensor; 5m Cable. £142.12 inc VAT Add to basket
Actisense Actisense DIN Rail Mounting Kit For use with the EMU-1, NDC-5 & NBF-3. Suitable for use with a top hat rail, type EN50 022 or a G section rail, type EN 50 035. The EMU-1 can be mounted horizontally (recommended) or vertically. £31.67 inc VAT Add to basket
Raymarine Raymarine Seatalk NG (STNG) 5 Way Connector The SeaTalk NG 5-Way connector creates up to 3 white spur connections in 1 location for connecting SeaTalk NG devices to the backbone. Dual blue ports connect to backbone cables allowing the network to pass-through to other locations on the boat, or accept network terminators to complete the circuit. £57.34 inc VAT Add to basket
NASA NASA Easy Navtex with Series 2 Antenna Nasa Easy Navtex with series 2 antenna. With big, bold characters for easy viewing and intuitive message formatting, this Navtex unit is very simple & easy to use. £356.42 inc VAT Add to basket
Actisense Actisense A2K-FFC-SM NMEA 2000 Field Fit Connector – Straight Male Allows for secure, reliable connections in any NMEA 2000 installation using Micro cable. Provides full flexibility and easy to install . The perfect complement to the Actisense 100M Bulk Reel of cable. £43.97 inc VAT Add to basket
NASA NASA 7 Metre Coaxial Extension Cable 7 metre coaxial extension cable with moulded connectors. £31.66 inc VAT Add to basket
Maretron Maretron Mini Termination Resistor Female Diagnostic versions indicate correct polarity at a glance to ensure power connections have been made properly. Screw connector for positive connection . Termination resistors are used to terminate both ends of the trunk line. £38.00 inc VAT View product
Raymarine Raymarine ST2 Adaptor Cable (5 Pin) ST2 Adaptor Cable (5 Pin) - 15.7in (0.4m). £36.67 inc VAT View product
NASA NASA Clipper Depth Sounder Best selling Depth sounder with giant 40mm high digits for easy viewing. The outstanding Clipper range of instruments incorporate technically advanced electronics in an industry standard 110mm square case. In The Box Display Unit, In hull depth transducer with cable, Weather Cover. £213.83 inc VAT Add to basket
NASA NASA 75cm MK1 (5 Wire) Wind masthead Unit Cable Replacement original equipment cable for the MK1 5 wire wind masthead unit. This is hard wired into the mast unit. Fitted with 5 pin DIN socket to attach to the 5 wire 20 metre mast cable connector. £30.80 inc VAT Add to basket
Raymarine Raymarine SeaTalk (ST1) to SeaTalk NG (STNG) Female Spur Cable – 1m ST1 Adaptor Cable (3 Pin) - 39.4in (1.0m). £36.67 inc VAT Add to basket
Raymarine Raymarine SeaTalk NG (STNG) to Devicenet (Female) adaptor Cable (1m) Raymarine SeaTalkng to devicenet (Nmea2000) female (F) adapter cable 1m. . £67.67 inc VAT Add to basket
NASA NASA Target 2 Depth Sounder The biggest selling marine instrument worldwide is still the depth sounder. In the Target sounder you will find all the necessary features of much higher priced units including keel offset, shallow and deep water alarms, and a depth range of 0.8 - 100 metres. £153.20 inc VAT Add to basket
NASA NASA BT3 Bluetooth Navtex comes with H Vector Antenna 518 and 490kHz message reception. 12 volt supply with low 27mA current consumption. Connects to H Vector or standard Series 2 antenna. Supply voltage 10 to 16 volts DC. Dimensions 135 x 100 x 30mm. Antenna length 195mm (complete with 7 metre cable). Supplied with active antenna, fused power cable and downloadable android app. Compatible with Android phones and tablets. £210.62 inc VAT Add to basket
Actisense Actisense A2K-FFC-SF NMEA 2000 Field Fit Connector – Straight Female Field fit connectors allow full customisation of your NMEA 2000 network cabling. Straight Female Version £43.43 inc VAT Add to basket
Maretron Maretron Mini Termination Resistor Diagnostic versions indicate correct polarity at a glance to ensure power connections have been made properly. Screw connector for positive connection. Termination resistors are used to terminate both ends of the trunk line. £60.00 inc VAT View product
