Oxford Oxford Loam 20 Nylon Flat Pedals – Red Oxford Loam Flat Pedals have been designed with a wide surface area and narrow profile for maximum grip and reduced pedal strikes. The 20 removable pins can be adjusted to fine tune the preferred level of grip, offering control no matter the trail conditions or environment you ride. £47.99 inc VAT Add to basket
Raymarine Raymarine Backbone Cable 3m SeaTalk ng Backbone cable - 3 m. In a SeaTalk ng installation, a backbone cable runs through the length of the boat. Individual devices connect to the backbone by spur cables that run to T-pieces on the backbone. The backbone carries both data and power to attached devices. The backbone should be sized so that it will run past every location where an NG or NMEA 2000 device might be installed. Two backbone cable lengths can be joined together by part A06030, a backbone extender. £57.34 inc VAT Add to basket
Maretron Maretron Micro Double-Ended Cordset Male to Female 1m Grey Double-ended cordsets are used for trunk or drop lines and make for a secure connection and simple timesaving installation. The connectors are keyed for error-free connection and they are waterproof for continued operation even while submerged in the bilge. £60.00 inc VAT Add to basket
Garmin Garmin GT30-TM 12 Pin Transom Mount Transducer Weight: 1.08 lbs. (0.50 kg). Cable length: 20’. Number of pins on connector: 12. Dimensions: Transducer: 7.8 x 1.5 x 0.9 in (198 x 38 x 22 mm). Frequency: DownVü: CHIRP 425-485 kHz and CHIRP 790-850 kHz, SideVü: CHIRP 425-485 kHz and CHIRP 790-850 kHz. Max Depth: DownVü: 750 ft, SideVü: 500 ft. Transmit power: DownVü: 500 W, SideVü: 500 W. £203.99 inc VAT Add to basket
Garmin Garmin GT20-TM 4 Pin Transom Mount Transducer An all in one dual function (HD-ID traditional and DownVu) transducer. Transducer comes with transom and trolling motor mounts, and installation instructions. Follow the instructions carefully to avoid damaging your boat. £130.80 inc VAT Add to basket
Maretron Maretron Micro Double-Ended Cordset Male to Female 0.5m Grey Double-ended cordsets are used for trunk or drop lines and make for a secure connection and simple timesaving installation. The connectors are keyed for error-free connection and they are waterproof for continued operation even while submerged in the bilge. £54.52 inc VAT Add to basket
Raymarine Raymarine Blanking Plug SeaTalk ng Blanking Plug - Inserted into unused spur connector positions in 5-way connector and T Piece. Place blanking plug in unused SeaTalkNG Spur sockets to protect them. SeaTalk ng is a robust cabling and connection system compatible with NMEA 2000, built specifically for the marine environment comprising a powered single backbone with two terminators, one at each end. Small diameter cable connectors are used throughout the system to make installation easier. There’s a wide range of cable lengths, all with over-moulded plugs, so there is no need to cut or splice cables. Spur cables connect individual SeaTalk ng products to the SeaTalk ng backbone. Cables and connectors are colour-coded for easy system identification and have quick connect (push-fit, twist-lock) waterproof (IPx6) plugs and sockets. Whether you are looking to expand your current SeaTalk ng system, update your electronics suite or completely refit, it couldn’t be easier with SeaTalk ng. £21.17 inc VAT Add to basket
Actisense Actisense DIN Rail Mounting Kit For use with the EMU-1, NDC-5 & NBF-3. Suitable for use with a top hat rail, type EN50 022 or a G section rail, type EN 50 035. The EMU-1 can be mounted horizontally (recommended) or vertically. £31.67 inc VAT Add to basket
Railblaza Railblaza E Series Cable Entry Port The E Series Cable Entry Port allows easy access for cables through the deck for tidy electronic mounting solutions. Wiring fishfinders, lighting, cameras and other electronics to your boat can be difficult and often leaves untidy cables in the way. £33.30 inc VAT Add to basket
Oxford Oxford Ultratorch Cube-X LED Light Set The Cube-X builds on the success of its predecessor, increasing the diode count on the COB LED from 36 to an impressive 140. £45.86 inc VAT Add to basket
Railblaza Railblaza CleatPort RIBMount – Black The CleatPort gives you a tie off point for stern lines and bow lines on small craft. The StarPort gives the extra functionality of adding any RAILBLAZA accessory. £45.43 inc VAT View product
Airmar Airmar DT800 P17 Smart Sensor 235kHz NMEA 0183 Airmar 44-084-1-01 DT800 P17 NMEA 0183 Smart Sensor with bare ends cable The DT800 utilizes Airmar’s proven Tilted Element™ and broadband technologies in this thru-hull depth and temperature Smart™ Sensor. The DT800 is a low-profile, retractable, thru-hull sensor that computes accurate depth and temperature data and sends it to any NMEA 0183 o display or network. Airmar's Smart Sensors have embedded microelectronics—the transducer element and signal processor are only millimeters apart. The signal from the depth transducer is processed right inside the sensor itself. All that is needed to receive depth and temperature data is a single cable into a compatible network or display. £1,119.00 inc VAT Add to basket
NASA NASA Wind Cup Kit Wireless and Tactical White Wireless & Tactical Wind cup kit. £33.20 inc VAT Add to basket
Railblaza Railblaza TracLoader StarPort This mounting base allows tool-free installation off accessories on the gunnel tracks of most aluminium fishing boats, including Crestliner Boats SureMount, Tracker VersaTrack, Lund Sport Trak, Lowe Boats and Princecraft PrinceTrak.With the mounting port to the side, this base is best for fitting drink holders, storage caddys, phone holders and fishfinders. £35.89 inc VAT Add to basket
Railblaza Railblaza E Series USB Starport The E Series USB StarPort combines a USB connector within our StarPort base allowing you to charge your tablets, mobile phones and many other devices. It is designed for use on a 12 VDC supply, rated at 2.1Amps. For charging only and not for data transfer. £45.43 inc VAT Add to basket
Railblaza Railblaza RibPort inc 3M VHB – Black Fit accessories like rod holders, bait boards, fish finders and more to RIB or Inflatable boats, SUPs and kayaks without hassle or messy glues. The new 3M VHB pad allows you to peel and stick the RIBPort mount, then fit any of your favorite RAILBLAZA accessories. The 3M VHB is now supplied with every RIBPort pack. £41.95 inc VAT View product
NASA NASA Wind Vane Kit Wireless and Tactical White Wireless & Tactical Wind vane kit. £33.20 inc VAT Add to basket
Railblaza Railblaza StarPort HD TracMount Kit Want a tool-free and centrally mounted lockable mount on your kayak track? StarPort HD can achieve this with the addition of the StarPort HD TracMount Kit. £24.62 inc VAT View product
