Garmin Garmin GT8HW-IH 8 Pin In Hull Transducer GT8HW-IH transducer is ideal for bass boats that want to install the transducer inside a fiberglass hull and not on the transom where cavitation could cause issues. It requires a flat section (<6°) in the hull to be mounted and is excellent for boats traveling at high speeds that want to maintain accurate depth readings.The 8-pin transducer features high-wide CHIRP traditional sonar (145-230 kHz) and has a power rating of 250 W. It can be used in conjunction with a GT30-TM transducer and an adapter cable so you can maintain depth at high speeds and scanning capabilities at trolling speeds. For installation, follow the included instructions carefully to avoid damaging your boat. £170.78 inc VAT Add to basket
Q-Link Q-Link Brand Ball Chain Dynamic Red 30” for Pendants Compatible with all Q-Link Pendants, except Titanium. Approximate Diameter: 2.2-2.4mm. Manufacturer Warranty: 30 Days. £24.96 inc VAT Add to basket
Raymarine Raymarine P79 Adjustable In-Hull Angle Compatible hull material: fiberglass. Max Power: 500W RMS (depending on connected SONAR). Frequency: 200/50 KHZ . Depth only. . Easily adjusts to any deadrise angle up to 22° . Transmits sound waves directly at the bottom so strong echoes are reflected back to the transducer . Can be removed in seconds for servicing or storage . Only the base piece is bonded to the hull. There is no adhesive layer under the transducer face to absorb sound energy . Simplifies in-hull installation . £230.66 inc VAT Add to basket
Q-Link Q-Link Brand Faceted Chain Copper 30” for Pendants Compatible with all Q-Link Pendants, except Titanium. Approximate Diameter: 2.2-2.4mm. Manufacturer Warranty: 30 Days. £28.94 inc VAT Add to basket
Raymarine Raymarine Backbone Cable 1m SeaTalk ng Backbone cable - 1 m. In a SeaTalk ng installation, a backbone cable runs through the length of the boat. Individual devices connect to the backbone by spur cables that run to T-pieces on the backbone. The backbone carries both data and power to attached devices. The backbone should be sized so that it will run past every location where an NG or NMEA 2000 device might be installed. Two backbone cable lengths can be joined together by part A06030, a backbone extender. SeaTalk ng is a robust cabling and connection system compatible with NMEA 2000, built specifically for the marine environment comprising a powered single backbone with two terminators, one at each end. Small diameter cable connectors are used throughout the system to make installation easier. There’s a wide range of cable lengths, all with over-moulded plugs, so there is no need to cut or splice cables. Spur cables connect individual SeaTalk ng products to the SeaTalk ng backbone. Cables and connectors are colour-coded for easy system identification and have quick connect (push-fit, twist-lock) waterproof (IPx6) plugs and sockets. Whether you are looking to expand your current SeaTalk ng system, update your electronics suite or completely refit, it couldn’t be easier with SeaTalk ng. £52.18 inc VAT Add to basket
Garmin Garmin Airmar P319 8 Pin Thru-Hull Transducer When using with a 6-pin Garmin sounder, transducer adapter cable part number 010-11612-00 is required. £214.01 inc VAT Add to basket
NASA NASA Alarm Buzzer Unit Alarm buzzer for the Clipper, Target or Cruiser Depth sounders. £22.88 inc VAT Add to basket
Q-Link Q-Link Brand Bead Chain Copper 30” for Pendants Compatible with all Q-Link Pendants, except Titanium. Approximate Diameter: 2.2-2.4mm. Manufacturer Warranty: 30 Days. £28.94 inc VAT Add to basket
Garmin Garmin GT30-TM 12 Pin Transom Mount Transducer Weight: 1.08 lbs. (0.50 kg). Cable length: 20’. Number of pins on connector: 12. Dimensions: Transducer: 7.8 x 1.5 x 0.9 in (198 x 38 x 22 mm). Frequency: DownVü: CHIRP 425-485 kHz and CHIRP 790-850 kHz, SideVü: CHIRP 425-485 kHz and CHIRP 790-850 kHz. Max Depth: DownVü: 750 ft, SideVü: 500 ft. Transmit power: DownVü: 500 W, SideVü: 500 W. £203.99 inc VAT Add to basket
Q-Link Q-Link Brand Ball Chain White 30” for Pendants Compatible with all Q-Link Pendants, except Titanium. Approximate Diameter: 2.2-2.4mm. Manufacturer Warranty: 30 Days. £24.96 inc VAT Add to basket
NASA NASA 7 Metre Coaxial Extension Cable 7 metre coaxial extension cable with moulded connectors. £31.66 inc VAT Add to basket
Q-Link Q-Link Brand Ball Chain Black 30” for Pendants Our Q-Link brand 30" color coded bead chains look especially great matched with Acrylic Pendants of the same color - and are an ideal, comfortable and practical alternative to the standard cord. Ultra-durable baked enamel coating is water-based, lead-free and non-toxic. £24.96 inc VAT Add to basket
Garmin Garmin GT8HW-IF 4 Pin Ice Fishing Transducer The GT8HW-IF transducer is perfect for ice fishermen who want clear bottom definition under the ice as well as crisp, clear and wide fish arches with excellent target separation. £170.78 inc VAT View product
Garmin Garmin GT23M-TH 8 Pin Thru-Hull Transducer Perfect for coastal and offshore fishermen who want CHIRP traditional sonar and CHIRP ClearVü scanning sonar with a stainless steel stem, this thru-hull mount transducer consistently displays clear and crisp fish arches with superior target separation as well as clear definition of structure below the boat. The 8-pin transducer features mid-band CHIRP traditional sonar (80-160 kHz) and has a power rating of 600 W. The CHIRP ClearVü (260/455 kHz) element has a power rating of 500 W. For installation, follow the included instructions carefully to avoid damaging your boat. £754.01 inc VAT Add to basket
NASA NASA Exhaust Temperature Monitor The EX-1 continually displays the exhaust gas temperature in wet exhaust systems giving advanced warning of potential problems. An alarm warns of excessive temperatures which could cause exhaust system damage, fires or leaks of toxic gases. It is supplied with a precision temperature sensor and cable to enable simple DIY installation. The EX-1 measures the exhaust gas temperature directly and displays it in degrees centigrade or Fahrenheit. Once the normal working temperature has been established a maximum temperature, a few degrees higher, can be programmed into the EX-1 which will then sound an alarm if that temperature is exceeded. Even a small rise in temperature can indicate a potential problem such as a minor blockage, leak or failing pump which can be corrected before a complete failure occurs. In The Box Monitor; Sensor; 5m Cable. £142.12 inc VAT Add to basket
NASA NASA Navtex Pro Engine with Series 2 Antenna Raymarine C & E Series Navtex Pro receiver with dual frequenct Navtex antenna for connection to PC or white version available to connect to Raymarine C & E Series Classic Plotters. £178.27 inc VAT View product
Q-Link Q-Link Brand Faceted Chain Stainless 30” for Pendants Compatible with all Q-Link Pendants, except Titanium. Approximate Diameter: 2.2-2.4mm. Manufacturer Warranty: 30 Days. £28.94 inc VAT Add to basket
NASA NASA BT3 Bluetooth Navtex S2 Antenna 518 and 490kHz message reception. 12 volt supply with low 27mA current consumption. Connects to H Vector or standard Series 2 antenna. Supply voltage 10 to 16 volts DC. Dimensions 135 x 100 x 30mm. Antenna length 195mm (complete with 7 metre cable). Supplied with active antenna, fused power cable and downloadable android app. Compatible with Android phones and tablets. £190.63 inc VAT Add to basket
Garmin Garmin GT21-TH 8 Pin Thru-Hull Transducer Perfect for coastal and offshore fishermen who want traditional sonar and CHIRP ClearVü scanning sonar with a stainless steel stem, this thru-hull mount transducer consistently displays clear and crisp fish arches with superior target separation as well as clear definition of structure below the boat. The CHIRP ClearVü element has a power rating of 500 W and operating frequencies of 260/455 kHz. The traditional sonar has a power rating of 600 W and operating frequencies of 50/200 kHz. It includes a built-in fast-response temperature sensor. For hull deadrises less than 25 degrees. GT21-TH includes an 8-pin transducer with stainless steel stem, fairing block, isolation plate and bushings, mounting hardware and installation instructions. Follow the instructions carefully to avoid damaging your boat. £524.00 inc VAT Add to basket
Raymarine Raymarine Backbone Cable 5m SeaTalk ng Backbone cable - 5 m. In a SeaTalk ng installation, a backbone cable runs through the length of the boat. Individual devices connect to the backbone by spur cables that run to T-pieces on the backbone. The backbone carries both data and power to attached devices. The backbone should be sized so that it will run past every location where an NG or NMEA 2000 device might be installed. Two backbone cable lengths can be joined together by part A06030, a backbone extender. £67.67 inc VAT Add to basket
Q-Link Q-Link Brand Waxed Cord Black Pack of 5 for Pendants Black waxed replacement cord for all Q-Link pendants. 5 per package. . £21.96 inc VAT Add to basket
Raymarine Raymarine Bronze B117 Low Profile Thru Hull transducer Compatible hull material: wood and fiberglass. Depth only. Max Power: 600 watts. Frequency: 200/50 KHZ . Cable: 9.1m/30ft. Hole diameter for installation: 2". £359.83 inc VAT View product
NASA NASA Navtex PC Pro Engine USB with Series 2 Antenna 518 and 490kHz message reception. 12 volt supply with low 27mA current consumption. Connects to standard Nasa Navtex antenna supplied. Supply voltage 10 to 16 volts DC. Dimensions 115 x 100 x 30mm. Antenna length 195mm (complete with 7 metre cable). Supplied with PC CD software, USB connection lead, fused power cable and Series 2 active antenna. Compatible with Windows XP to 8. £178.27 inc VAT Add to basket
Garmin Garmin 6 Pin Transducer to 8 Pin Sounder Connector Block Garmin 8Pin Female to Wire Block Adapter. £81.00 inc VAT Add to basket
Garmin Garmin GT23M-TM 8 Pin Transom Mount Transducer GT23M-TM transducer is perfect for coastal and offshore fishermen who want CHIRP traditional sonar and CHIRP ClearVü scanning sonar. This transom mount transducer consistently displays clear and crisp fish arches with superior target separation as well as clear definition of structure below the boat. The 8-pin transducer features mid-band CHIRP traditional sonar (80-160 kHz) and has a power rating of 600 W. The CHIRP ClearVü (260/455 kHz) element has a power rating of 500 W. For installation, follow the included instructions carefully to avoid damaging your boat. £344.00 inc VAT Add to basket
Garmin Garmin GT30-TH 12 Pin Thru-Hull Transducer Perfect for the shallow water fisherman who want CHIRP ClearVü and CHIRP SideVü scanning sonar with a stainless steel stem, this 12-pin thru-hull transducer consistently displays clear definition of objects, structure and fish below and to each side of the boat. £664.01 inc VAT View product
