Scanstrut Scanstrut DS16-P Grey Plastic Vertical Cable Seal 2-8mm IP68 vertical entry cable seal For cables from 2-8mm (0.08"-0.35"), connectors up to Ø16mm (0.63") an aesthetic dome-shaped profile provides a stronger, impact-resistant design and captive nuts in the base make for an easy assembly. £36.00 inc VAT Add to basket
Raymarine Raymarine Backbone Cable 400mm SeaTalk ng Backbone cable - 0.4 m. In a SeaTalk ng installation, a backbone cable runs through the length of the boat. Individual devices connect to the backbone by spur cables that run to T-pieces on the backbone. The backbone carries both data and power to attached devices. The backbone should be sized so that it will run past every location where an NG or NMEA 2000 device might be installed. Two backbone cable lengths can be joined together by part A06030, a backbone extender. £52.18 inc VAT Add to basket
Garmin Garmin 12 Pin Transducer Extension Cable – 10ft (3m) Garmin 3m Transducer Extension Cable 12pin With XID. £55.00 inc VAT Add to basket
Raymarine Raymarine Backbone Cable 3m SeaTalk ng Backbone cable - 3 m. In a SeaTalk ng installation, a backbone cable runs through the length of the boat. Individual devices connect to the backbone by spur cables that run to T-pieces on the backbone. The backbone carries both data and power to attached devices. The backbone should be sized so that it will run past every location where an NG or NMEA 2000 device might be installed. Two backbone cable lengths can be joined together by part A06030, a backbone extender. £57.34 inc VAT Add to basket
Scanstrut Scanstrut DS16-S Stainless Steel Vertical Cable Seal 2-8mm IP68 vertical entry cable seal For cables from 2-8mm (0.08"-0.35"), connectors up to Ø16mm (0.63") an aesthetic dome-shaped profile provides a stronger, impact-resistant design and captive nuts in the base make for an easy assembly. £53.60 inc VAT Add to basket
NASA NASA Battery Monitor Clipper BM1 24 VDC The BM-1 is designed to monitor performance of 24 Volt lead acid battery systems with capacities of up to 600 Amp hours. It is supplied complete with a precision 100 AMP shunt and a prefabricated cable assembly to enable simple DIY installation. The unit continuously monitors voltage, current (charge or discharge), number of amp/hours (charge or discharge), the batteries state of charge and the time to charge or discharge. This information leads to more efficient use of the battery, which can enhance battery life and reduce the risk of failure. £123.62 inc VAT Add to basket
