Avtex Avtex Tourer Three GPS Navigator – Caravan & Motorhome Club Edition The new Avtex Tourer Three comes packed with features specifically for use with caravans and motorhomes. Simply enter the size and weight of the motorhome or towing outfit and the Avtex Tourer Three will give directions to the destination avoiding height, width, and weight restricted roads whilst providing route warnings such as sharp bends or steep hills along the way. £443.99 inc VAT Add to basket
Raymarine Raymarine Masthead Trans Service Kit (D) Replacement Vane and Windcups for the old ST50 and the earlier D windcup ST60 MHU. £67.67 inc VAT Add to basket
Maretron Maretron Micro Double-Ended Cordset Male to Female 2m Grey Double-ended cordsets are used for trunk or drop lines and make for a secure connection and simple timesaving installation. £65.51 inc VAT Add to basket
Raymarine Raymarine Wind Vane Service Kit Replacement Vane and Windcups for the ST60 MHU. £88.32 inc VAT Add to basket
Maretron Maretron Micro Double-Ended Cordset Male to Female 0.5m Grey Double-ended cordsets are used for trunk or drop lines and make for a secure connection and simple timesaving installation. The connectors are keyed for error-free connection and they are waterproof for continued operation even while submerged in the bilge. £54.52 inc VAT Add to basket
Raymarine Raymarine SeaTalk NG (STNG) Backbone Terminator SeaTalk ng Terminator - Fitted at each end of backbone, two are required per system. SeaTalk ng is a robust cabling and connection system compatible with NMEA 2000, built specifically for the marine environment comprising a powered single backbone with two terminators, one at each end. Small diameter cable connectors are used throughout the system to make installation easier. There’s a wide range of cable lengths, all with over-moulded plugs, so there is no need to cut or splice cables. Spur cables connect individual SeaTalk ng products to the SeaTalk ng backbone. £31.51 inc VAT Add to basket
Raymarine Raymarine Backbone Cable 400mm SeaTalk ng Backbone cable - 0.4 m. In a SeaTalk ng installation, a backbone cable runs through the length of the boat. Individual devices connect to the backbone by spur cables that run to T-pieces on the backbone. The backbone carries both data and power to attached devices. The backbone should be sized so that it will run past every location where an NG or NMEA 2000 device might be installed. Two backbone cable lengths can be joined together by part A06030, a backbone extender. £52.18 inc VAT Add to basket
