Oxford Oxford Ultratorch Cube-X LED Light Set The Cube-X builds on the success of its predecessor, increasing the diode count on the COB LED from 36 to an impressive 140. £45.86 inc VAT Add to basket
Oxford Oxford Loam 20 Nylon Flat Pedals – Black Oxford Loam Flat Pedals have been designed with a wide surface area and narrow profile for maximum grip and reduced pedal strikes. The 20 removable pins can be adjusted to fine tune the preferred level of grip, offering control no matter the trail conditions or environment you ride. £47.99 inc VAT Add to basket
NASA NASA BT3 Bluetooth Navtex S2 Antenna 518 and 490kHz message reception. 12 volt supply with low 27mA current consumption. Connects to H Vector or standard Series 2 antenna. Supply voltage 10 to 16 volts DC. Dimensions 135 x 100 x 30mm. Antenna length 195mm (complete with 7 metre cable). Supplied with active antenna, fused power cable and downloadable android app. Compatible with Android phones and tablets. £190.63 inc VAT Add to basket
NASA NASA 75cm MK1 (5 Wire) Wind masthead Unit Cable Replacement original equipment cable for the MK1 5 wire wind masthead unit. This is hard wired into the mast unit. Fitted with 5 pin DIN socket to attach to the 5 wire 20 metre mast cable connector. £30.80 inc VAT Add to basket
NASA NASA Clipper Depth Sounder Best selling Depth sounder with giant 40mm high digits for easy viewing. The outstanding Clipper range of instruments incorporate technically advanced electronics in an industry standard 110mm square case. In The Box Display Unit, In hull depth transducer with cable, Weather Cover. £213.83 inc VAT Add to basket
NASA NASA 7 Metre Coaxial Extension Cable 7 metre coaxial extension cable with moulded connectors. £31.66 inc VAT Add to basket
NASA NASA Exhaust Temperature Monitor The EX-1 continually displays the exhaust gas temperature in wet exhaust systems giving advanced warning of potential problems. An alarm warns of excessive temperatures which could cause exhaust system damage, fires or leaks of toxic gases. It is supplied with a precision temperature sensor and cable to enable simple DIY installation. The EX-1 measures the exhaust gas temperature directly and displays it in degrees centigrade or Fahrenheit. Once the normal working temperature has been established a maximum temperature, a few degrees higher, can be programmed into the EX-1 which will then sound an alarm if that temperature is exceeded. Even a small rise in temperature can indicate a potential problem such as a minor blockage, leak or failing pump which can be corrected before a complete failure occurs. In The Box Monitor; Sensor; 5m Cable. £142.12 inc VAT Add to basket
