Description
- Max Input Voltage: 70V
- Warranty: 5 Years
Use this cable to connect a Skylla-i to a VE.Bus BMS. The VE.Bus BMS will then disable the Skylla-i charger when the batteries are fully charged. This cable is intended for on/off control of the Skylla-i when the source signal is high when the Skylla-i must be on and low or free floating when Skylla-i must be off.
Upgrade Options
Alternative or higher-specification products you may also wish to consider.
Victron
Victron Skylla-i Battery charger 24v/100a (1+1)
Features include: Temperature sensor, use as a power supply, forced cooling, Remote on-off port (can be connected to a Li-Ion BMS), Synchronised parallel operation with VE.Can. Input voltage / input voltage range: 230 V AC / 185-265 V AC. Maximum AC input current @ 180 VAC: 16 A. Frequency: 45-65 Hz / Power factor: 0.98. Charge voltage 'absorption'/'float'/'storage': 28.8 V DC / 27.6 V DC / 26.4 V DC. Battery capacity: 500-1000 Ah. Protection: IP21 / Battery reverse polarity (fuse), Output short circuit, Over temperature. Charge current / starter batt.: 100 A / 4 A. Charge algorithm / Charge algorithm - Li-Ion : 7 stage adaptive / 3 stage, with on-off control or CAN bus control. Operating temp. range / Humidity (non condensing): -20 to 60°C / max 95%.
Victron
Victron
Victron Skylla-i Battery Charger 24v/80a (1+1)
Skylla-i (1+1): two isolated outputs to charge 2 battery banks. The second output, limited to approximately 4 A and with a slightly lower output voltage, is intended to top up a starter battery. Rugged - Aluminium epoxy powder coated cases with drip shield and stainless steel fixings withstand the rigors of an adverse environment: heat, humidity and salt air. Circuit boards are protected with an acrylic coating for maximum corrosion resistance. Temperature sensors ensure that power components will always operate within specified limits, if needed by automatic reduction of output current under extreme environmental conditions.
Victron
