Description
Controlled charging
Every TG Charger has a microprocessor which accurately controls the charging in three steps. The charging process takes place in accordance with the IUoUo characteristic and charges more rapidly than other processes.
Use of TG Chargers as a power supply
As a result of the perfectly stabilized output voltage a TG Charger can be used as a power supply if batteries or large buffer capacitors are not available.
Two outputs to charge
2 battery banks (24V models only) The TG Chargers feature 2 isolated outputs. The second output limited to approximately 4A and with a slightly lower output voltage is intended to top up a starter battery.
To increase battery life: temperature compensation
Every Skylla TG Charger comes with a battery temperature sensor. When connected charge voltage will automatically decrease with increasing battery temperature. This feature is especially recommended for sealed batteries which otherwise might be overcharged and dry out due to venting.
Battery voltage sense
In order to compensate for voltage loss due to cable resistance TG Chargers are provided with a voltage sense facility so that the battery always receives the correct charge voltage.
Upgrade Options
Alternative or higher-specification products you may also wish to consider.
Victron
Victron Skylla-i Battery charger 24v/100a (1+1)
Features include: Temperature sensor, use as a power supply, forced cooling, Remote on-off port (can be connected to a Li-Ion BMS), Synchronised parallel operation with VE.Can. Input voltage / input voltage range: 230 V AC / 185-265 V AC. Maximum AC input current @ 180 VAC: 16 A. Frequency: 45-65 Hz / Power factor: 0.98. Charge voltage 'absorption'/'float'/'storage': 28.8 V DC / 27.6 V DC / 26.4 V DC. Battery capacity: 500-1000 Ah. Protection: IP21 / Battery reverse polarity (fuse), Output short circuit, Over temperature. Charge current / starter batt.: 100 A / 4 A. Charge algorithm / Charge algorithm - Li-Ion : 7 stage adaptive / 3 stage, with on-off control or CAN bus control. Operating temp. range / Humidity (non condensing): -20 to 60°C / max 95%.
Victron
Victron SDTG2400504 Skylla-TG 24/50 GMDSS 120/240V Battery Charger
The Victron Energy Skylla-TG 24/50 GMDSS chargers has been designed to provide all required monitoring and alarm data. Both the battery and the GMDSS system are connected directly to the charger. Data and alarms are displayed on a digital panel, VE.Net GMDSS panel. A standard eight wire UTP cable connects the charger to the panel.
Victron
Victron
Victron Skylla-i Battery Charger 24v/80a (1+1)
Skylla-i (1+1): two isolated outputs to charge 2 battery banks. The second output, limited to approximately 4 A and with a slightly lower output voltage, is intended to top up a starter battery. Rugged - Aluminium epoxy powder coated cases with drip shield and stainless steel fixings withstand the rigors of an adverse environment: heat, humidity and salt air. Circuit boards are protected with an acrylic coating for maximum corrosion resistance. Temperature sensors ensure that power components will always operate within specified limits, if needed by automatic reduction of output current under extreme environmental conditions.
